Irrigation Pump Remote Control ( 480VAC 3-Phase ) for Wheel Lines

  • Listed: December 3, 2017 5:57 pm
  • Expires: 32 days, 12 hours
  • Street: 208 Main
  • City: Declo
  • State: Idaho
  • Country: United States
  • Zip/Postal Code: 83323
  • Price: $329.00

Description

Tired of driving out to turn the pump on and off to change the water, un-hook ends, make repairs, and fix bad plugs?
Worried about broken pipes causing floods, power loss in the middle of the night, or pipes that have come apart?

We were – so we’ve constructed an RF ( Radio Freq ) remote control to turn on and off our irrigation pumps as well as monitor and notify us of any issues. The setup connects to most standard 3-Phase 480VAC pump panels. The purchase doesn’t include the transducers required to monitor pressure and ditch water level; those can be purchased directly from the suppliers and easily wired to the Controller.

————————————–
Features of this item
————————————–
* A solid rural 2-Mile range ( XBee RF claims up-to 28-mile range )
* No cellular, FCC licensing or other requirements are needed
* A single Hand-Remote can control multiple irrigation pumps
* Multiple Hand-Remotes can control the same irrigation pump
* Uses the Pump Panels “AUTO” selection; doesn’t disturb manual operation
* Implements the “Stay-Off” after power loss; req. by power companies
* Easily [expandable] to offer Pressure and Water-Level monitoring
* Built using mass-produced dev-boards that can be easily purchased

————————————–
Included in the purchase
————————————–
* (1) Hand-Remote Unit
* (1) Pump-Controller Unit with cable and plug
* (1) EBL 9V Li-ion battery charger
* (2) EBL 9V 600mAh Li-ion batteries

[ 1- Installation Kit; including ]
– A 480VAC 3-Phase to 24Vdc power supply on a DIN Rail
– A 480VAC or Higher Solid State Relay on a DIN Rail
– A Pump Panel Exit plug for attaching the Pump-Controller Unit
– Drill Bit and Thread Tap for #8-32
– 2x #8-32 Machine screws
– Automatic center punch

An Order page exists at
https://www.etsy.com/listing/525674784/irrigation-pump-remote-control-480vac-3

————————————–
Installation Process Overview
————————————–
[ Tools Required ( Not Supplied ) ]
– Cordless Drill
– Small Phillips Screwdriver
– Small Flat-Head Screwdriver
– Wire Cutter & Strippers

[ Wiring ]
– 4x Wires from L1, L2, L3, GND to Power Supply
– 2x Wires from Solid State Relay to Selector & Start button
– 3x Wires of the panel ‘Exit Plug’ to SSR Input & Power Supply

The Units will be ready to use upon the completion of installation shortly described above. Firmware will already be loaded on purchased units as well as a charged battery already in the Hand-Remote. The firmware on both units can be customize to your particular needs using a computer and USB connection.

————————————–
An Open Source Project
————————————–
A fully detailed user manual with installation, building, and modifying instructions can be viewed at:
https://tgit23.github.io/AgIrrigationRemoteControl/manual/

      

44 total views, 2 today

  

Listing ID: 93659e7742055dab

Report problem

Processing your request, Please wait....